aboutsummaryrefslogtreecommitdiffstats
diff options
context:
space:
mode:
-rw-r--r--README.md10
1 files changed, 3 insertions, 7 deletions
diff --git a/README.md b/README.md
index 0a25168..a3833c4 100644
--- a/README.md
+++ b/README.md
@@ -16,18 +16,14 @@ You'll need at least `bossac` installed somewhere in your path in
order to actually do the flashing. You'll also need rust installed for
your target device.
-1) Grab the above branch and stick it one directory level up (e.g., if
-this is checked out into `~/src/atsamd-usb-host` the `atsamd-hal`
-checkout should be in `~/src/atsamd`).
-
-2) Connect a serial port to your device (the Trinket M0 uses pin 4 to
+1) Connect a serial port to your device (the Trinket M0 uses pin 4 to
do UART transmission at TTL voltage).
-3) Plug the device in, put it into firmware-update mode (double-tap
+2) Plug the device in, put it into firmware-update mode (double-tap
the reset button on the Trinket M0) and run `make flash`. When it's
done you should see boot messages on your serial device.
-4) Unplug the device from the computer, hook it up to another power
+3) Unplug the device from the computer, hook it up to another power
supply somehow (I wire GND to ground and USB to 5V), plug in a
keyboard, and hit some keys. You should see it print out the keyboard
reports as keys are pressed and released. Alternately, you may see