From d4d1af6a7bce0a9d99faa4d5704211e18b2843ee Mon Sep 17 00:00:00 2001 From: Brian Cully Date: Sun, 11 Aug 2019 13:06:14 -0400 Subject: Update README. Don't need special branch anymore. --- README.md | 10 +++------- 1 file changed, 3 insertions(+), 7 deletions(-) diff --git a/README.md b/README.md index 0a25168..a3833c4 100644 --- a/README.md +++ b/README.md @@ -16,18 +16,14 @@ You'll need at least `bossac` installed somewhere in your path in order to actually do the flashing. You'll also need rust installed for your target device. -1) Grab the above branch and stick it one directory level up (e.g., if -this is checked out into `~/src/atsamd-usb-host` the `atsamd-hal` -checkout should be in `~/src/atsamd`). - -2) Connect a serial port to your device (the Trinket M0 uses pin 4 to +1) Connect a serial port to your device (the Trinket M0 uses pin 4 to do UART transmission at TTL voltage). -3) Plug the device in, put it into firmware-update mode (double-tap +2) Plug the device in, put it into firmware-update mode (double-tap the reset button on the Trinket M0) and run `make flash`. When it's done you should see boot messages on your serial device. -4) Unplug the device from the computer, hook it up to another power +3) Unplug the device from the computer, hook it up to another power supply somehow (I wire GND to ground and USB to 5V), plug in a keyboard, and hit some keys. You should see it print out the keyboard reports as keys are pressed and released. Alternately, you may see -- cgit v1.2.3