use core::sync::atomic::{AtomicUsize, Ordering};
use log::trace;
use nrf52840_hal::{
    clocks::LfOscStopped,
    rtc::{self, RtcInterrupt},
    Clocks, Rtc,
};

struct MilliClock(AtomicUsize);
impl MilliClock {
    const fn new() -> Self {
        Self(AtomicUsize::new(0))
    }

    #[allow(unused)]
    fn set(&self, millis: usize) {
        self.0.store(millis, Ordering::SeqCst)
    }

    #[allow(unused)]
    fn add(&self, val: usize) -> usize {
        self.0.fetch_add(val, Ordering::SeqCst)
    }

    // Slightly less than 1ms, due to using a 32,768Hz clock, we can't
    // hit exactly 1ms, so we shoot for a bit under.
    fn millis(&self) -> usize {
        self.0.load(Ordering::SeqCst)
    }
}

static CLOCK: MilliClock = MilliClock::new();

pub fn setup<R, H, L>(
    mut rtc: Rtc<R, rtc::Stopped>,
    clock: Clocks<H, L, LfOscStopped>,
) -> impl FnMut()
where
    R: rtc::Instance,
{
    trace!("setting up clock");

    clock.set_lfclk_src_rc().start_lfclk();

    // Try to set clock to 1kHz.
    match rtc.set_prescaler(32) {
        Ok(()) => trace!("set prescaler!"),
        Err(x) => trace!("couldn't set prescaler: {:?}", x),
    }
    // Make sure event is cleared before start.
    let _ = rtc.get_event_triggered(RtcInterrupt::Tick, true);

    let mut rtc = rtc.enable_counter();
    move || handler(&mut rtc)
}

pub fn millis() -> usize {
    CLOCK.millis()
}

fn handler<R>(rtc: &mut Rtc<R, rtc::Started>)
where
    R: rtc::Instance,
{
    let _ = rtc.get_event_triggered(RtcInterrupt::Tick, true);
    CLOCK.add(1);
    log::logger().flush();
}